Enlarge the picture to see the laser beam on top of each of the fuselage supportsI decided to go ahead and start from scratch on the leveling of the jig. So I removed the fuselage and then cut the legs and shimmed to get level both directions. I also went ahead and glued the jig to the floor with epoxy.
After the epoxy exercise I went back and checked for level again, used three different levels and all agreed. So I went ahead and started positioning the fuselage back on the jig. At this point I have everything back on but only the firewall bulkhead and the instrument panel bulkhead in their final positions.
No comments:
Post a Comment